These boot files can be downloaded from here. Clover can also use a selection of boot files, these are boot2, boot3, boot6, boot7 and boot8 (\boot is the default file - but we won't be using this).Īlso we need a special modified PBR boot file called \Clover\boot1F32ALT7. USB\EFI\CLOVER\themes\metal is 4MB) - you can delete this 'themes\xxxx' folder and/or replace it with a different theme folder. (optional) Some themes are quite large (e.g.If present, delete the large 3MB Russian PDF in the USB\EFI\CLOVER\doc folder (unless you speak Russian and find it useful!).Delete from the USB folder the USB\ EFI\BOOT folder (the Clover \EFI\BOOT\xxx.efi files must NOT be present - these will cause a UEFI boot to boot back to Clover again!).Delete from the USB folder the USB\ usr, USB \Library and folders (if present).Make a copy of the orig folder and call it USB - i.e.You should now have a folder structure like this (ones in red not required):.Unzip it and then unzip the Clover2k-xxxx-X64.iso file to your C:\temp\Clover\orig folder. Alternatively, download a bootable Clover ISO from here - e.g.Tip: Press 7 immediately after it starts to boot to Clover if you have problems booting. You can use this flash drive immediately (on a real system not under QEMU) for testing.Then copy the files from the USB drive to a folder on your system's hard disk - e.g. ![]() I recommend you download BootDiskUtility and use it to install Clover onto a spare USB Flash drive. It contains boot1F32ALT7 and PBR.BIN files and a modified ist file to show boot圆4.efi entries plus the ntfs.efi driver in the drivers64 folder - or you can make your own version as follows.
0 Comments
Leave a Reply. |